ECET 340 UOP Course Tutorial / Uoptutorial

ECET 340 UOP Course Tutorial / Uoptutorial

  • Submitted By: lucky64
  • Date Submitted: 09/02/2014 3:30 AM
  • Category: Business
  • Words: 526
  • Page: 3
  • Views: 1

ECET 340 Entire Course
For more course tutorials visit
www.uoptutorial.com


ECET 340 Week 1 HomeWork 1
ECET 340 Week 1 iLab 1
ECET 340 Week 2 HomeWork 2
ECET 340 Week 2 iLab 2
ECET 340 Week 3 HomeWork 3
ECET 340 Week 3 iLab 3
ECET 340 Week 4 HomeWork 4
ECET 340 Week 4 iLab 4
ECET 340 Week 5 HomeWork 5
ECET 340 Week 5 iLab 5
ECET 340 Week 6 HomeWork 6
ECET 340 Week 6 iLab 6
ECET 340 Week 7 HomeWork 7
ECET 340 Week 7 iLab 7
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

ECET 340 Week 7 HomeWork 7

For more course tutorials visit
www.uoptutorial.com


1. The movable part of the solenoid is the: +2 points
2. Why is the 6N139 optoisolator used in the interfaces to devices such as large motors? +2 points
3. Calculate the number of steps per revolution for a stepper motor with a step angle of 7.5°. +2 points
4. How is stepper motor speed controlled? State any two ways a program can do this. +2 points
5. For this problem, you should look at Figure 5A on the next page as a physical example of a stepper motor. It is an example of a stepper motor with four (4) magnetic windings which are connected via an interface circuit to the HCS12 Port T pins 4, 5, 6, & 7, with an armature (rotor) that has 12 poles (combined number of North and South magnetic poles). Notice how each step rotates the rotor 30 degrees, and notice the logic states on the Port T pins going from Step 1 to Step 2. To rotate the rotor 90 degrees, you would need three (3) steps (see figure 5A for explanation).
6. Identify 2 major kinds of devices that can be used to interface a dc motor to the HCS12. +2 points
7. Given that pulses need to be delivered to a specific dc motor at the rate of 12.5 kHz to avoid vibration, write down the C statements needed to output pulses from the HCS12 to drive the at 80% of its full drive level. +2 points
8. An...

Similar Essays