ECET 340 Uop courses/Uophelp

ECET 340 Uop courses/Uophelp

ECET 340 Entire Course (All ilabs and Homework) (Devry)


For more course tutorials visit
www.uophelp.com


ECET 340 Week 1 HomeWork 1
ECET 340 Week 1 iLab 1
ECET 340 Week 2 HomeWork 2
ECET 340 Week 2 iLab 2
ECET 340 Week 3 HomeWork 3
ECET 340 Week 3 iLab 3
ECET 340 Week 4 HomeWork 4
ECET 340 Week 4 iLab 4
ECET 340 Week 5 HomeWork 5
ECET 340 Week 5 iLab 5
ECET 340 Week 6 HomeWork 6
ECET 340 Week 6 iLab 6
ECET 340 Week 7 HomeWork 7
ECET 340 Week 7 iLab 7

..........................................................

ECET 340 Week 2 HomeWork 2 (Devry)

For more course tutorials visit
www.uophelp.com

1. Where does program control transfer to when an interrupt occurs? +2 points
2. Which one of the following Interrupts has highest priority? +2 points
3. RAM Vector table addresses $3E52 belongs to which interrupt? +2 points
4. Before exiting an ISR, the programmer should use which command? +2 points
5. In which one of the following sequences is the stack pulled by rti? +3 points
6. Given the starting address for the TC0 Interrupt is to become $5000. Write the assembly instruction necessary to place this ISR address into the interrupt vector table and then unmask the interrupt (assembly only). +3 points

............................................

ECET 340 Week 4 HomeWork 4 (Devry)

For more course tutorials visit
www.uophelp.com

1. Determine the conversion time for an ADC0804 (8-bit), where 66 clocks per bit are required, if its clock frequency is 50 kHz.

2. If an 8-bit SAR has Vref = 10 V, what is the binary value for an input voltage of 7.28 V?

3. What is the percent error for the binary answer found in Problem #2?

4. Given an 24 MHz bus speed. Write down the line(s) of instruction which set the ATD1 unit for 2MHz conversion frequency, 10-bit resolution and 8 A-to-D clocks per sample time.

5. A single 10-bit, left justified conversion of 3.75V is complete in ATD0. Assume and
i. Name the register(s) where the...

Similar Essays