NETW420
ADVANCED NETWORK MANAGEMENT
Fault Management
School of Engineering and Information Sciences
SUBMITTED BY:
SUBMITTED ON: 22 February 2015
Table of Contents
Questions 1-2 3
Questions 3-6 4
Questions 7-10 6
Questions 11-14 7
Questions 15-18 8
Questions 19-23 9
Questions 24 12
Document Certification 14
Questions 1-2
1. What is the average database response time and what is the average HTTP page response time?
The average database response time is approximately 55 and the HTTP response time is approximately 100 bytes/sec.
DB and HTTP page response time
2. What does the panel tell us about the utilization on this link?
The percent utilization for the A router spikes quickly to 100 percent.
Percent utilization
Questions 3-6
Database Query Traffic Received
3. What was the range (low to high) in bytes per second (or Kbytes per second) of database traffic received by the users for the No_Redundancy run?
The range from low to high is approximately 50 Kbytes per second of the traffic received for the No_Redundancy run.
4. What was the range (low to high) in bytes per second (or Kbytes per second) of database traffic received by the users for the Redundancy_Load balance run?
The range from low to high is approximately 100 Kbytes per second of the traffic received for the Redundancy Load balance run.
5. What was the range (low to high) in bytes per second (or Kbytes per second) of database traffic received by the users for the DS1_Link Failure run?
The range from low to high is approximately 50 Kbytes per second of the traffic received for the DS1 Link failure run.
6. In your estimation, was the amount of database traffic received by the users approximately the same for all three runs?
The amount of traffic received for the No Redundancy and the DS1 Link fail was approximately the same while the traffic received peaked slightly higher at the same instances.
Questions 7-10
Database Query Response...