How to make a taser
Hello ladies and gentlemen, my name is Callum Worsley and today I am going to teach you how to make a high voltage taser, non-deadly of course.
First of all, we’ll start off with the things you need, the items needed are very easy to get a hold of and you shouldn’t have to spend more than $20. Now, the main item you need is a disposable camera with a flash, the flash is essential so don’t forget it. Next, you will need some wire, any normal single strand wire will do, don’t bother with any expensive insulated wire. A soldering iron and some solder will also be necessary. That’s about all you need really, not much eh?
Now, once you have all the equipment, grab the camera and find out where the batteries are located, this is so you don’t shock yourself when dismantling the camera. Once you have found the batteries, take them out but don’t throw them away as they will be needed later on. Once the batteries are out of the way, start dismantling the camera. There should be a few clips on each side of it; there should be no screws involved. Once you have found the clips, unclip them and the camera casing should come off, it may take a bit of elbow grease to separate the two halves of the case but it is relatively easy.
Now that you have taken the case off, a circuit board will be visible. Now comes the tricky part, you must locate two points on the circuit; the two points that the capacitor connects to, these are the points that the capacitor prongs connect to, they are located here *show diagram*. Once you have located these points, grab your wire and soldering iron and solder each wire to each point, so that the wires are separated.
Once that part is done, all you have to do is put the case back on, be careful not to rip the wires out in the process. Find a small hole that the wires can fit out of so that they are held in place by the case, like this *show on diagram*. Once the case is on, grab the batteries from before and put...