ECET 340 Entire Course (All ilabs and Homework) (Devry)
For more course tutorials visit
www.uophelp.com
ECET 340 Week 1 HomeWork 1
ECET 340 Week 1 iLab 1
ECET 340 Week 2 HomeWork 2
ECET 340 Week 2 iLab 2
ECET 340 Week 3 HomeWork 3
ECET 340 Week 3 iLab 3
ECET 340 Week 4 HomeWork 4
ECET 340 Week 4 iLab 4
ECET 340 Week 5 HomeWork 5
ECET 340 Week 5 iLab 5
ECET 340 Week 6 HomeWork 6
ECET 340 Week 6 iLab 6
ECET 340 Week 7 HomeWork 7
ECET 340 Week 7 iLab 7
......................................................................................................................................................
ECET 340 Week 1 HomeWork 1 (Devry)
For more course tutorials visit
www.uophelp.com
1. Give three examples each of internal and external peripheral devices as referenced to the HCS12 microcontroller and not an entire PC. (2 points)
2. Given “the requirements of each signal’s destination must match the capabilities of the signal’s source,” name some of the electrical signal parameters that must be considered when designing an interface between two different hardware components. (2 points)
3. Write down the instructions needed to program PORT A for pins PA7, PA4-PA0 as inputs and PA6-PA5 as outputs. Answer should be a valid C language statement. (2 points)
4. Write an instruction sequence to output the value $35 to PORT P. Use the C language only when writing your answer; - no assembly language. (2 points)
...............................................................................................................................................
ECET 340 Week 2 HomeWork 2 (Devry)
For more course tutorials visit
www.uophelp.com
1. Where does program control transfer to when an interrupt occurs? +2 points
2. Which one of the following Interrupts has highest priority? +2 points
3. RAM Vector table addresses $3E52 belongs to which interrupt? +2 points
4. Before exiting an ISR, the programmer should use which...