How to eliminate oil mill hydraulic oil press failure

How to eliminate oil mill hydraulic oil press failure

  • Submitted By: emmafuqian
  • Date Submitted: 09/11/2014 12:01 AM
  • Category: Business
  • Words: 358
  • Page: 2
  • Views: 1

Hydraulic oil press is composed of hydraulic and press the two most commonly, the common faults and elimination method of hydraulic press is commonly the following.Hydraulic oil vendors would forrest today will share with you here, if do oil mill's friends, learn the fault elimination method of hydraulic oil press, can help you save a lot of time and effort.palm oil plant
Hydraulic oil press can't pump oil
General hydraulic oil opportunities appear this kind of phenomenon the reason is: (1) of the hydraulic oil press oil screen blockedSteam pipe;(2) of the hydraulic oil press used for a long time, the oil in the oil valve deposits, cause the throttle is not closed;(3) of the hydraulic oil press oil tank is too strong, or because of cold coagulation;(4) the fuel tank of hydraulic oil mill medium oil quantity is insufficient;(5) in the hydraulic pump of hydraulic oil press is not a vacuum.
Can't pump oiling fault elimination method is: (1) clean the hydraulic oil press oil screen;(2) the replacement of new oil or hydraulic oil press release old oil;Filter and clean the hydraulic oil press oil inlet valve, and grinding, make the good hydraulic pressure oil confidential;、Rice bran oil dewaxing
(3) replace the hydraulic oil press thin oil, cold room temperature should be increased;(4) to add sufficient oil tank;5. Pull out the small piston, again after injection oil pressure.Hydraulic oil opportunities appear this kind of phenomenon the reason is: (1) hydraulic oil press out dirt or oil valve is poor contact;(2) the hydraulic oil on board in and out of the valve plug and seat poor contact or not tighten caused by oil;(3) hydraulic oil press small piston and the pump body wear clearance is too large.
Hydraulic oil press hydraulic pump pressure not enough fault elimination method is: (1) after the hydraulic oil press to grinding unpick and wash, make the seal;(2) grinding on the hydraulic oil in and out of the valve plug and seat, make its closed or tighten...

Similar Essays