Start
T5
Torx
Driver
Lift this tab
Straight up
PalmOne Tungsten E2 with T5 Torx
screwdriver
Remove 4 Torx screws from
rear of unit
Positive
Battery
Lead
Using case opening tool
Release plastic snap detail
holding rear cover to front case
Battery
Docking
Connector
Unplug Battery cable from
motherboard. For future reference
positive lead is facing away from
the docking connector as shown
at left. (continued on page 2)
Tools Required: Case opening tool, T5 Torx
Screwdriver
Battery connector
on Motherboard
Note: Antistatic Procedures must be
followed when handling all electronics
Page 1 of 2
Caution: battery cable is
connected to the battery
that is fastened to the rear
cover and to the battery
connector on the
motherboard
PDA Smart
Cedar Park, Texas
Description:
PalmOne Tungsten E2
Disassembly Instructions
Date:
Created By:
10/12/2007
T Mattox
Plastic Fascia
Lift this tab
Straight up
If the battery is to be replaced,
carefully lift it from the double stick
tape using the case opening tool.
If only replacing the battery, stop here.
Unplug the LCD Data cable by lifting
on the flex cable with your finger on
The left side. *
Carefully lift the plastic fascia
From the front cover assembly
Lift the motherboard from the
front cover assembly. *
END
Disassembly is complete. Re-assembly
Is the reverse of this process.
Tools Required: Case opening tool, T5 Torx
Screwdriver
Lift the LCD assembly from the
front bezel. *
*Note: Antistatic Procedures must be
followed when handling all electronics
Page 2 of 2
PDA Smart
Cedar Park, Texas
Description:
PalmOne Tungsten E2
Disassembly Instructions
Date:
Created By:
10/12/2007
T Mattox