Screw press use the operating instructions and matters needing attention:
L, lubricating oil each part listed as required.
2, check fastening parts, operating handle, flashboard is flexible.
3, with the hand carry large pulley, check whether there is any loosening or stuck on the machine.If there is abnormal in a timely manner to eliminate.
4, loosen the lock nut, squeezer shaft twist to the dead point, and then back to 3-4 laps, go forward, half a circle in order to protect
Squeeze the clearance between the circle in cake and screw.
5, degree of tightness of the belt can be adjusted.Drive the ejecting axis of rotation of pulley is a duplex sheave, if small sheave slag serious available.
6, the door is open the electrical appliances, air switch in position of the inside power, start the motor, check whether large sheave rotating direction and tag in the same direction.
7, adjust the temperature controller, temperature adjustment to squeeze the 150-200.C (according to oil).Twist the host heating switch machine for heating to heat up, then the green light on the temperature controller, a red light, when the temperature rise of the sunflower oil press (http://www.sunflowermill.com) machine to the set temperature, red light and green light go out.The temperature of the machine is in automatic control and maintain the set temperature 150-200.C, when the winter low temperature, heat the oil pan, switch to oil pan temperature, ease of oil flow.
8, slow boot after feeding should be uniform, began to feed not too strong, or more, less, otherwise may be made
To squeeze bore clogging and stuck machine accidents.Began to feed the bread should be thicker, normal after the cake, engine temperature of 150-200.C may will be normal squeezing embryo into the hopper.
9, the machine run properly after observing that the cake situation, if not a cake, squeezer to exit the l can be a 2 laps, such as
Is not a cake, should stop check, remember to put an end to go against the...