Three Usual Stoppages and Resolvents of China Magnetic Separator

Three Usual Stoppages and Resolvents of China Magnetic Separator

China magnetic separator is the key equipment in mineral processing. It is used to remove iron powder in powder grain of reuse, etc. China magnetic separator is applicable to wet magnetic separation of material such as magnetite, magnetic pyrite mine, baking, titanium iron ore, manganese ore which is below 3mm, also is used in coal, non-metalliferous ore, building materials, and other materials for removing iron homework.There are some the common faults and causing reasons about China magnetic separator.1. The electrical machine of China magnetic separator is overheated and its sound is not normal.The cause of the failure is: 1) the lubrication of bearing is bad or wear is serious; 2) fan leaves fall off or wear; 3) line contact of switch is undesirable, or break line runs single-phase; 4) voltage is too low.2. Reducer is overheated: The cause of the failure is: 1) the oil is not enough or oily is bad; 2) worm and gear have serious wear or mesh is bad; 3) lubrication of bearing is bad or severe worn.3. The sound is not normal in China magnetic separator running, cylinder gets stuck by the barrier, and even cylinder cannot turn, the bottom cases are trembling. The cause of the failure is that it often gets stuck by object of the bottom cases, otherwise magnetic piece falls off, to make the cylinder body be creaky, it is serious that the tube skin is broken. At this time, we should stop to maintain and remove the faults.When we master the common failures and reasons about the China magnetic separator, we can find problems and solve problems in time. So we can maintenance and repair of China magnetic separator equipment, it is the important prerequisites for us to use equipment in right ways and to ensure construction.china magnetic separator: http://www.sell-crusher.com/pro/p16.html

Similar Essays