Hydraulic oil vendors would forrest found that the effect of hydraulic press pressing oil, there are many factors that can influence, but the main two aspects including press structure and squeezing conditions.In addition, the hydraulic oil press equipment structure and the selection to a certain extent will also affect the effect of oil.Squeeze the influence of the structure of vats material structure refers to the mechanical structure and structure inside and outside two aspects.palm oil plantThe structure of the press material properties mainly depends on the pretreatment, primarily steaming and frying, good or bad, and the composition of the oil itself.The general requirements of press material structure.Press material particle size should be appropriate and consistent, press material inside and outside of the structure of the good consistency and press material better, less the number of complete cell press material density in does not affect the internal and external structure under the premise of the more the better.For press material oil viscosity and surface tension in the lower as far as possible, press material particles have enough plasticity.
First of all, with the increase of squeeze material moisture content, its plasticity is also gradually increased.When the water reaches a certain point, squeeze out the oil is best, when the moisture content is referred to as "optimal moisture" or critical moisture.For a certain press material, under certain conditions, the optimal water has a relatively narrow range.Of course, the optimal moisture range at the same time and other factors, first is temperature, protein denaturation degree are closely related.Factors influencing the press material structural properties.In many press structure properties of squeeze material mechanical properties, especially the plasticity of the largest, and the effects of squeeze oil.Squeeze in oil, other conditions including shell and roughly the same case, its plasticity is...