First, before the use of screw press must first carefully read this manual, are familiar with the performance characteristics and method of operation of the machine.
Second, the screw press before the start. Must first conduct a comprehensive inspection, not loose fasteners, handles flexible rotation, rotation of the pulley by hand, each operating parts should be normal, no abnormal sound, followed by deceleration box filling the 20th mechanical oil. Loosen the lock nut, turn the adjustment screw so squeezed tight against the cone snails out of the mouth of the cone cake, then unscrew the adjustment screw clockwise two turns, then tighten the lock nut, ready to boot.
Third, adjust the temperature control unit transferred to press the desired temperature 130-180 degrees (depending on fuel availability): Turn the total heating switch the machine to heat up, then the temperature controller on the green light, red light goes off when the machine. when the temperature rises to a set temperature, and the red light, green light is off, the temperature of the machine is automatically controlled and maintained at the set temperature 130-180 degrees. Forward button pressed host host starts running, the helical axis should turn counter-clockwise direction.
Fourth, the screw press equipment installation should be 2-8 hours grinding virgin: Method is already pressed oil cake feed (rapeseed cake soybean, peanut cake, cotton cake or cotton shell, rice husk can be.) slowly fed from the hopper back repeatedly pressing. so pressing screw polished, the cake, forming smooth, remember to start grinding pressed not to feed directly into the hopper, and fed to the clutch is appropriate to prevent the pressing screw shaft stuck; such as feeding excessive, abnormal sound or pressing screw shaft stuck in the virgin bore, should be immediately stopped, eliminate obstruction, re-assembled and then start grinding virgin, non-forcible trailer or inverted pouring.
Fifth, often oil, must be...