After the purchase of new equipment to a normal use, it requires a slower transition period. This will not only ensure the normal operation of construction machinery decreased failure rate, but also extend its service life. But now, most users ignore small details, due to lack of use knowledge for impact crusher, or because of the tight schedule, or would like to get return profit as soon as possible. Some users have even holding the points that the manufacturers have warranty period, the machine manufacturer is responsible for repairing when this is something wrong with the machine. So the machine in the running overload during the transition period, this will result in frequent problems on machines. This not only affects the normal application of the machine and shorten the life of the machine, but also because the machine destroyed, affecting the progress of the project. Therefore, the use and maintenance of impact crusher in transition period should be considered as important aspects.
When cone crusher is working normally,to separate hydraulic station and crusher,and storage them in a ready use and clean place. The steps are as follows: 1.cut off the hydraulic station motor power,and cut off the connection line between motor and power. 2.Make the control valve handle or the buttons locate in a pressure relief place 3.View the pressure gauge on the hydraulic station,and make sure the pressure gauge reading is Zero. When the pressure gauge reading is higher than zero,never allowed to set down multiple fittings body or the soft tube on the clearing cavity jack.Checking again is to ensure control valve handle or buttons in the pressure relief place.Under the pressure situation,to remove the soft tube,because the spraying oil speed is very high,the free end of the swinging soft tube may be hurt,so it”s very dangerous. 4.Slowly loosen mutiple fittings body or the soft tube on the cleaning cavity jack,before completely disconnecting the soft tube,to release the...