When we buy a expensive machine, we all hope we can used it longer. However, the result maybe do not always satisfied. What we can do to realize our dream? One beautifull person had said that if you want have the skin as the age of 18, then you should begin to protect you skin at your18. As to ball mill or other machine that you buy, it is the same.Host-axis was should be the level and the ends of the hollow shaft should in the same height, but it is allowed that the feed-side higher than the discharge end about 1mm. The gap surrounding the hollow shaft should be basically the same as surrounding the bearing gland.After the host installation, the installation of transmission part can begin. Firstly, you should check the assembly of the transmission part, mainly examine whether the pinion shaft and the reducer of low-speed shaft is concentric.Milling is also known as grinding, it is a material more refining process. A sharp object works by concentrating forces which creates a high pressure due to the very small area of the edge, but high pressures can nick a thin blade or even cause it to roll over into a rounded tube when it is used against hard materials. Henan Hongxing Machinery can provide all kinds of advanced material milling equipment for you to choose.Install and adjust the transmission part based on the host’s large gear, So that the width of the both sides of the pinion gear is the same as the large gear, gear tooth surface of the large gear are parallel to the pinion gear and gear backlash should be at least 0.25mm. From the size of the gear contacts traces to see, the length of contacts traces should be at least 60% of the length of the gear and the height of contacts traces should be at least 40% of the height of the gear.If the contacts traces lean to the one side, namely, that tooth surface is not parallel. If the large gear is jammed, namely, the gap between the gears is too small, which should be enlarged.dry mining equipment:...