FIRST machinery factory today to tell you about the structure of peanut oil press and screw press virgin bore using CR12 mold steel, this new peanut oil press Hengtong machinery research and development of three-stage crushing process and electronic temperature control system, this machine automatic control of temperature and moisture squeezed to make direct oil to soften, activate fat molecules, press stability, again pressed the net, the oil yield increased substantially. Press with peanut sheller machine, vacuum oil purifier system, automatic refining filtration, oil pure, convenient and practical, production capacity, comprehensive Hsi out microorganisms, oil pure clear. Automatic oil giant brand active force using copper motor drive, wear resistance, low energy consumption, acting big, automatic clutch down, feeding the average rate. Press speed, without geographical climate impacts, can be widely used peanut, rapeseed, soybean, sesame, sunflower, flax, mountain tea seed, cotton seed, walnuts, almonds, pepper seeds, pepper seeds, tung seed, castor and all other oilseeds crushing. this is such a peanut oil press made some direction as well as a brief introduction to use, but there is a problem is that many customers are more concerned about the issue, in case of slag press appeared to run over multi-how to do ah, this issue Hengtong machinery professionals already considered, and has given us to do something about this side of the adjustment measures and analyzes the reasons look at it:
Peanut oil press run excessive slag
① individual cage bars bent or gap is too large. At this point, you can remove the juice bar, with gauze or Whetstone alpha- virgin strip three convex side polished, straight juice bar reloading, some thin metal pad, if necessary, the gap remains within the range of 0.05-0.08 mm.
② oil plastic is bad, the cake difficult to make the machine bore pressure increases. In this case, the right amount of oil should be mixed with water, and the...