Installation of energy-saving ball mill and the fittings should pay attention to what the problem

Installation of energy-saving ball mill and the fittings should pay attention to what the problem

In order to play the effect of energy saving ball mill, first of all to the correct installation of host and fittings, correct use, regular maintenance to maximize the life of the machine. We ask the following technical personnel to introduce the installation of energy-saving ball mill and the transmission part should pay attention to the problem.
1, energy-saving ball mill installation of host:
Axis mill host should be horizontal, top is measured in the hollow shaft flange on both ends, the height should be consistent, allowing the feeder is higher end 1mm. in the bearing gland at both ends of the hollow shaft error, hollow shaft should be consistent with the gap around the bearing gland, and inner and outer gland at should be basically the same slot.
2, energy-saving ball mill transmission part of the installation:
After adjustment of good level in the host, can drive part of the installation. First check the ball mill transmission part quality assembly, check the main concentric pinion shaft and reducer low speed shaft.
In order to host large gear as the benchmark, ball mill installation and adjustment of the transmission part. The small gear tooth width than the big gear tooth surface on both sides of uniform width. The ball mill small gear tooth surface and the surface of the large gear backlash in parallel, with minimum stay at 0.25mm (about hard box cigarette packing paper layer). From the size of the gear contact traces, contact traces should be accounted for more than 60% of the length of the contact trace, height accounted for about 40% of all high.
If the end of the tooth surface contact traces to the width of the tooth surface, that is not parallel. If the drive gear extrusion die in a week, the gear gap is too small, should make the small gear left the big gears a bit.
if you want know more about it ,please visit my website:
http://www.beneficiationmachine.net/products/grinding/ball-mill.html...

Similar Essays