Learn together under the centrifugal oil filter cleaning step, each operator must be to understand the
FIRST machinery based on their own strengths, with a more powerful force, a broader perspective, more effective measures, more effective way, leading entrepreneurs to launch a new round of wealth storm, FIRST will create a more glorious era, hand in hand Hengtong, you will last a lifetime! ?
Centrifugal oil filter cleaning steps:
A centrifugal oil filter off, disconnect the power.
2 Remove the oil drain plugs pollutant room, and then connect the oil pan with oil until the oil flow have been exhausted (you can press the gas when you put the oil drain plug and accelerate out of the oil), and then re-tighten the input connector block cover.
3 Remove the centrifuge input connector, centrifuge output connector, remove the protective cover centrifuge, remove the belt, while 16 with a wrench unscrew the four screws on the base of the centrifuge, the centrifuge from the body the removed oil pan in place.
4 Remove the bleed plug centrifugal oil filter, and then loaded on the location-specific removal tools, fittings screwed onto the cover, twist 3-4 laps, tighten the nut on the bolt to the roots, while the bolts to the pressure plate, screwed in the end.
5 rotating nut, so that the centrifuge housing sink in the end. Obtained at the end face of the cover 6 is pressed by the small groove in the downward projection of the collar, then removed from the housing in the groove of the collar.
Separate loosen nuts and bolts out, then screwed onto the pipe joints pressure plate, screwed in the end, so that the cover and the contact position. Remove the cover and then manually manually.
7 with a brush to remove surface deposits within the housing, and then wipe clean with a rag to cover.
8 Remove the pressure plate, remove the titanium core portfolio, into the oil pan, use gasoline or kerosene soaked 20 minutes after cleaning and blowing with an air gun.
9...